Gliderol G+ TM390 GEN 2 Remote Instructions

GENESIS and GENESIS OPTIMA

Programming a new remote.


Press the ‘Code’ button and ‘-.-‘ will become visible
on the display
Press and hold the desired button on your remote that you would like to operate your door until the dots shown on the display flash.

Clearing the memory

To erase all stored remote information, simply press and hold the ‘CODE’ button for more than 8 seconds. The dots shown on the display will disappear to confirm all remote programming information has been erased.

Video Instructions

Please note: this video shows the TM390+ with grey buttons. These remotes are not compatible however they program the same.

ROLLAMATIC – GEN 2

Programming a new remote.

Press and hold the ‘Enter’ button (shown above) for 2 seconds to access the operator menu. The unit will beep twice to confirm this has been selected.

Use the arrow (Up & Down) buttons to select the ‘Learn’ option and press ‘Enter’ to confirm selection. The unit will beep three times to confirm the unit is in Learn mode.
Press and hold the desired button for operation on the handset. Hold down until every light in the status bar on the powerhead (as shown above) is lit up

Clearing the memory

To erase all stored remote information, simply press and hold the ‘CODE’ button for more than 5 seconds.

share post:

Leave a Reply

Your email address will not be published. Required fields are marked *