Features:

• Versatile remote available in a 1,2,4 or 5 button variety (this listing is for the 4 button)
• Simultaneously transmits the encrypted code on 5 different frequencies, making it impossible for the remote to be interfered with or jammed
• Uses frequency hopping spread spectrum (FHSS)
• Operating range of up to 100 metres depending on building structure and receiver antenna
• Wide operating supply voltage and low current consumption ▪ Momentary and latching modes are user selectable. ▪ On-board diagnostic LED’s to indicate correct power, reception and relay activation
• Although the FOB43304 is available in 4 colours the general colour supplied in FOBKITS is Orange.  The colour will vary depending on stock levels at the time of purchase. 
• Designed in Australia
• Free Delivery Australia-Wide*
• 2 Years Manufacturers Warranty*

Each FobKit  comes with:

• 1 x 1 Ch Wire In Receiver PCR43301RE
• 3 x Genuine Brand New Orange FOB43304 remotes
• 3 x Battery
• 3 x Keyring Attachment
• Coding Instructions

There are multiple variations of this product

• FOBKIT 43301 with 2 Channel Plugin
• FOBKIT 43301 with 2 Channel Wire In
• FOBKIT 43301 Large button with 1 Channel in enclosure
• FOBKIT 43301 Large button  with 2 Channel Plugin
• FOBKIT 43301 Large button with 2 Channel Wire In
• FOBKIT 43302 button with 1 Channel in enclosure
• FOBKIT 43302 button  with 2 Channel Plugin
• FOBKIT 43302 button with 2 Channel Wire In
• FOBKIT 43304 button with 1 Channel in enclosure
• FOBKIT 43304 button  with 2 Channel Plugin
• FOBKIT 43304 button with 2 Channel Wire In
• FOBKIT 43305 button with 1 Channel in enclosure
• FOBKIT 43305 button  with 2 Channel Plugin
• FOBKIT 43305 button with 2 Channel Wire In
• Waterproof FOBKIT 43301 with 1 Channel in enclosure

How to Program the Elsema PentaFOB® remotes

Remote to Receiver

1. Check that all switches are “OFF” on the receivers 12-way dip switch
2. Press and hold the program button on the receiver
3. Press the remote button for 2 seconds, receiver LED will flash and then turn Green
4. Release the button on the receiver and the remote
5. Press remote control button to test the receiver output

Remote to Remote (you will need to be near the receiver for this procedure)

If your receiver was manufactured prior to 2016

1. Open the case of a remote control that is already programmed and press and release the program button on the back of the board (The receiver enters learning mode)
2. Press the button of the remote in step 1 which activates the receiver
3. Press the button on the new remote which needs to be programmed for 2 seconds
4. Press the program button again of the remote in step 1(The receiver exits learning mode)
5. Press the new remote control button to test the receiver output

If your receiver was manufactured 2016 onwards

1. Open the case of a remote control that is already programmed and press and release the program button on the back of the board
2. Press the new remote control button for 2 seconds
3. Press the new remote control button again to test the receiver output

Video Programming