Features:
- Genuine original equipment remote
- Free Standard Shipping Australia-Wide*
- 2 Years Manufacturers Warranty*
Includes:
- Brand New Remote
- 1 x Battery
- Coding Instructions
- Keyring Attachment
Merlin M842 was created to the public request for a key-ring version. Uptake for this design was incredible and it still remains number 1 in sales to date. This item has been so popular that after over a year out of the market it has been re-released by Merlin with a new and improved back that meets the Lithium Battery Standards in Australia.
IS THIS THE RIGHT REPLACEMENT REMOTE FOR ME?
The MERLIN M842 Remote is compatible with:
- MERLIN M832 remote
- MERLIN M844 remote
WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.
If you suspect your child has swallowed a button battery or placed inside any part of the body immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.
Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.
Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).
FINDING THE LEARN BUTTON OVERHEAD & TILT DOOR OPENERS
1. Opener with 5 exposed terminal screws at the rear – Remove the small black cover to the right of the terminal screws. LEARN is the red button under the black cover
2. Opener with 4 terminal screws at the rear – often this is covered with a plastic panel – Remove the lamp cover, remove the red or green control panel cover, find the small button marked LEARN
3. Opener with 4 covered terminal screws at the rear and a Merlin wired wall switch – The small button on the Merlin WALL SWITCH is the LEARN button
PROGRAMMING ROLLER DOORS
1. Single small square red button on the front – Remove the lamp cover, then the small black cover to the left of the lamp holder LEARN is the red button under the black cover
2. Large red or green push-switch on front – Remove the red or green control panel cover find the small button marked LEARN Large red or green push switch on front and a Merlin wired wall control switch – The small button on the Merlin wall switch is the LEARN button
Programming to RECEIVERS -Dark grey boxed receiver with a large round green button
The LEARN button is the small dark grey button inside the green button.
Programming to RECEIVER CARDS
The LEARN button is the small switch on the PCB marked LEARN.
CODING THE REMOTE – DOOR ONLY
Press the learn button for 1 – 2 seconds – Courtesy lamp will flash & click
Press the desired remote control button twice
CODING THE REMOTE – DOOR & LIGHT
Press the learn button for 1 – 2 seconds
Press the desired remote control button for the main function
Press the desired remote control button for the secondary function
DELETING REMOTES
Press LEARN button for about 11 seconds – The lamp will flash slowly & switch off – All remotes are now deleted!
