Features:

• Genuine original equipment remote
• Free standard delivery Australia-wide*.
• 2 Years Manufacturers Warranty*

Includes:

• Brand New Genuine Remote
• 1 x Battery
• Coding Instructions

The NICE ERA INTI 4 Remote is compatible with:

• NICE FLOr-s 1
• NICE FLOr-s 2
• NICE FLOr-s-4
• NICE ONE 1
• NICE ONE 2
• NICE ONE 4
• NICE VERY BLACK
• NICE ERA INTI 2 BUTTON

The NICE ERA INTI Remote is NOT compatible with:

• NICE FLO 1 (10 Switch)
• NICE FLO 2 (10 Switch)
• NICE FLO 4 (10 Switch)

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).

CODING VIA WORKING REMOTE

Only Top 2 buttons on NICE FOr-s remotes can be copied

• Be within 3 meters of your installation
• Press a button on your NEW remote control for 5 seconds
• Pick up a remote already coded – Slowly press an already activated button 3 times waiting 1 second between each press and pressing for about 1 second each time
• Press the same button on your NEW remote control & release.
• Wait 10 seconds, your new remote control is coded.

CODING VIA A RECEIVER/CONTROL BOARD

• Open the box of your receiver. It is located near the motors.
• On the receiver circuit board, press & hold the coding button, Release when the receiver LED lights up.
• Press & hold a  button on your NEW remote control, Release when the receiver LED goes off
• Wait one second, Press the same button on your new remote control, Release when the receiver LED flashes 3 times.
• Wait 10 seconds, your NEW remote is now coded.