Features:

• Genuine original equipment remote
• Free Standard Delivery Australia-wide*
• 2 Years Manufacturer Warranty*

Includes:

• Brand New Remote
• 1 x Battery
• Coding Instructions

Compatibility List:

Remotes:

• DEA GOLD 2 Button remote
• DEA GOLD 4 Button remote
• DEA GENIE R remote
• DEA MIO TR2 remote
• DEA MIO TR4 remote

This exciting new design is backwards compatible with later DEA remotes.   Featuring a bold but sleek new design with centrally located buttons for easy use, this remote includes a unique BILLION CODE system, guaranteeing you maximum safety.   This new remote gives longer battery life & better range

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).

RECEIVER WITH NO LCD SCREEN

• Open the casing of your receiver box. it can be found next to your motor
• Press the programming button on the circuit board of the receiver and then let it go (button ENR, MEMO, PROG, or RESET, depending on the model).
• The LED light on the receiver lights up or blinks.
• Press a button on your new remote control for 1 second.
• Let the button go. The LED light on the receiver goes out immediately or in the following 10 seconds depending on the model.
• Your new remote control is programmed.

Repeat for more remotes.

RECEIVER WITH A DIGITAL SCREEN

• Open the casing of your receiver box. It can be found next to your motor.
• Press the buttons + or – on the receiver circuit board until you see the entry P005 on the digital screen.
• Press OK. The LED lights up.
• Press a button on your new remote control for 1 second
• Wait 10 seconds.
• Your new remote control is programmed.

Repeat for more remotes.

DELETING REMOTES

Press the programming button on the circuit board of the receiver for 8 to 10 seconds and then let it go (button ENR, MEMO, PROG, or RESET, depending on the model). All remotes are now deleted.