ELSEMA PENTAFOB 1 BUTTON LARGE REMOTE FEATURES:

• Genuine original equipment remote
• Free Standard Delivery Australia-wide*
• 2 Years Manufacturers Warranty

Each replacement remote comes with:

• Brand New Remote
• 1 x Battery
• Coding Instructions
• Keyring Attachment

Choose from:

• Orange, Lime, Blue, Black or Red Case

Note:  Colour options are slowly being discontinued by the manufacturer.  We will endeavour to supply your preferred colour option but substitutions may occur.  

The HIGH-SECURITY PentaFOB® uses frequency hopping spread spectrum (FHSS). This means that when a button is pressed, it simultaneously transmits the encrypted code on five different frequencies. This makes it impossible for your remote control to be interfered with or jammed.

Available in 1, 2, 4 and 5 button configurations. The key-ring retainer is molded as part of the chassis using reinforced nylon making for a super sturdy key-ring mount.  The PentaFOB® series is an extremely versatile remote control that can be customized through a range of configurations and colours to suit your needs.

How to Program the Elsema PentaFOB® remotes

Remote to Receiver

1. Check that all switches are “OFF” on the receivers 12-way dip switch
2. Press and hold the program button on the receiver
3. Press the remote button for 2 seconds, receiver LED will flash and then turn Green
4. Release the button on the receiver and the remote
5. Press remote control button to test the receiver output

Remote to Remote (you will need to be near the receiver for this procedure)

If your receiver was manufactured prior to 2016

1. Open the case of a remote control that is already programmed and press and release the program button on the back of the board (The receiver enters learning mode)
2. Press the button of the remote in step 1 which activates the receiver
3. Press the button on the new remote which needs to be programmed for 2 seconds
4. Press the program button again of the remote in step 1(The receiver exits learning mode)
5. Press the new remote control button to test the receiver output

If your receiver was manufactured 2016 onwards

1. Open the case of a remote control that is already programmed and press and release the program button on the back of the board
2. Press the new remote control button for 2 seconds
3. Press the new remote control button again to test the receiver output

Video Programming