Features:

• 1 x Genuine Remote
• 2 Years Manufacturers Warranty*
• Free Standard Shipping Australia-Wide*

Includes:

• 1 x Brand New Remote
• 1 x Battery
• Coding Instructions

Compatibility List:

Motors:

• Mistral 324 Swing Gate Motor
• Trigon Swing Gate Motor
• Blizzard 4 Sliding Gate Motor

Remotes:

• ADYX TE4433H remote
• GENIUS TE4433H
• GENIUS BRAVO

Boldly designed in a trendy shiny black case with white highlights. his remote is well made & should handle daily life well.  Fits onto your Key-Ring.

Programming via Receiver

• On the receiver, press the push-button for the channel you wish to code – SW1 to store CH1 and SW2 to store CH2.
• LED 1 or LED 2 will light on steady light to signal that the receiver is in learning mode.
• Press on the remote within 10 seconds and hold down the push-button you wish to code for at least 1 second.
• If storage was successful, the LED flashes twice.
• After the first remote has been coded, the receiver stays in learning mode, with the LED lighted on steady light.
• To code successive remotes (up to a maximum of 256), repeat the operations from point 2
• When 10 seconds have elapsed from coding of the last remote, the receiver automatically exits the learning stage.
• You can exit the learning procedure manually, by pressing one of the push buttons on the receiver (SW1 or SW2) after the remote has been stored.

Programming from a working remote

• With your already-programmed remote control and your new remote control, proceed to the vicinity of the receiver.
• On the pre-programmed remote control, simultaneously press the P1 and P2 buttons and hold it until the two LEDs L1 and L2 flash on the receiver. Release the buttons.
• While the two LEDs will flash on the receiver, press the button you want to program. The LED (L1 or L2) which is assigned to the button will flash.
• While the LED is flashing, press on the new remote control, the button to be programmed. The receiver LED will flash, then lights up permanently. Release the button.
• After 10 seconds, the LED on the receiver goes out.
• Your new remote control is now programmed.