Features:

• Genuine NICE HOME product
• Four large buttons and 1 side button means 5 separate applications on one remote
• Compatible with NICE HOME and MHouse systems
• Free Shipping Australia-Wide*
• 2 Years Manufacturers Warranty*

Includes:

• 1 x Genuine NICE HOME remote
• Battery
• Programming Instructions

Compatibility:

Note:  This system was previously branded MHouse and was also imported under the name Downee.

• MHouse GTX4
• MHouse TX4
• MHouse Moovo

Note:  NICE HOME is not affiliated with Nice Australia and their remotes are not compatible with each other.

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).

Programming Instructions

Mode 1:  Preset 4 Buttons

• On Controller , Press P1 (Slide) and P4 (Swing) until LED light is on steady
• Within 10 seconds, Press and hold any button on your NEW remote until the LED light flashes three times
• LED light will stay on for 15 seconds to allow for additional remotes to be paired.

Preset Mode:

Mode 2:  Choose your own function for each button

• On the controller press and release key P1 (swing motor) or P4 (slide motor) the number of times for the command
• Within 10 seconds, press and hold the remote button to be used for minimum 2sec: if the connection is made, the LED will flash 3 times.
• To connect other remotes with the same command, repeat step 03 within 10 seconds; otherwise, the connection phase will end.