Overhead Openers (SD800/SD1200)

Programming New Remotes

• Press and Hold “P” and “+” buttons until all lights turn on and the LED #7 flashes
• Press the “+” button once (all LED lights turn off except LED #7)
• Quickly press and release the required push button on your remote twice (all LED lights turn on and LED #7 will begin flashing)
• Press the “P” button once to save (LED 3 will switch on indicating that the remote has been successfully programmed).
• Repeat above procedure for all additional handsets

Note: Most of these openers have 10 positions in the memory. 

Deleting Remotes

This procedure will clear all programmed remotes, wireless wall buttons and wireless keypads from your opener.

• Press and Hold the “P” and “+” buttons until all lights turn on and LED 7 flashes.
• Press and Hold the “-“ button until LED 7 turns off and begins flashing again.
• Press the “P” Button once to save (LED 3 will switch on indicating that all codes have been deleted)

Roller Door Openers (RD800/RD1200)

Programming New Remotes

• Press the “LEARN” button once (LEARN LED will turn on and unit will beep 3 times)
• Within 10 seconds, press and release the button on your NEW remote once.
• All LED’s will switch off

Motor will automatically leave Learning mode after 10 seconds with no activity.

Note: Most of these openers have 15 positions in the memory. You will need to follow the delete remotes procedure to clear the memory and start again.

Deleting Remotes

This procedure will clear all programmed remotes, wireless wall buttons and wireless keypads from your opener.

• Press and hold the “LEARN” button for seven (7) seconds; Learn LED will turn on with three beeps, unit will beep another two times followed by one long beep).
• All LED”s will switch off indicating that memory has been cleared.